The BKL Technologies Long Dovetail Rings for 1in Scopes are made for shooters who demand stability. These Riflescope Rings by BKL Technologies are lightweight and made with high quality materials. Designed to fit standard 3/8in and 11mm dovetails, the BKL Technologies Independent Long Dovetail Rings are made for 1in scope tubes with an overall clamp and ring length of 0.60in. When you need rings as strong as your firearm, choose the BKL Technologies 200 Series Long Dovetail Rings. Specifications for BKL Technologies 0.6in Long Dovetail Rings, Series 200: Manufacturer: BKL Technologies Tube Diameter: 1 in Condition: New Mount Type: Dovetail Package Contents: BKL Technologies 0.6in Long Dovetail Rings, Series 200, BKL-257
6 reviews for BKL Technologies 0.6in Long Dovetail Rings, Series 200
Only logged in customers who have purchased this product may leave a review.
Related products
Celtic –
Well made and finished. Fit to rail is tight and secure. Only issue is standard height is too tall for scopes under 50mm. They need a set 0.2" lower. Mounted Vortex 4x12x40AO Crossfire II on CZ455 and clears the barrel and bolt by 0.4".
Pistol –
Tried the other more pricey rings, but these are the go to rings for CZ rifles especially the cz 455 American. Vortex 4x12x40mm AO fit with plenty of clearance. Customer support even returned my call to tell me they would fit. BKL is a gr8 company, buy with confidence
CR –
These are very nice and affordable rings especially considering they are made in the USA. They are solidly built and i also like that they use larger screws than most other rings which should mean they are less likely to strip.
Buglemintoday –
Went through Rimfire Central looking for the correct rings for my CZ452 American.The BKL Standard rings are perfect for the 452 American odd-ball (3/8") mount. Prior to these BKL Rings I tried the Factory CZ rings as well as a set of Leupold "High" Rings. The CZ and Leupold rings would not clamp "square" to the receiver….was not impressed since the CZ rings were $70ish and the Leupold rings weren't far behind that.I am very impressed with the BKL rings. First off — They are Made in TEXAS! Received the tip on this brand from RimfireCentral. $19.99 and the Standard height will fit a 40mm objective. I wouldn't suggest the BKL "Tall" rings unless you are wanting to put a 50mm scope on.Installed a Vortex Crossfire II 4-12x40AO scope and boresighted.The big issue with mounting a scope on the 452/455 is bolt-to-ocular end clearance. The BKL rings cleared the ocular end of this scope with ease.I hope this post helps someone out who is wanting to mount a scope on their 452/455.
Vincenzo –
Have 11mm dovetail. These look well made but they are really hard to tighten. The hex head screws weren't best quality and hard to get the wrench into. Also when you slide the ring onto the dovetail, it's hard to hold the ring in place and tighten because it takes a lot of effort to tighten. Not impossible, but just annoying. Ended up needing higher mounts so going to try a different brand with the two piece clamping.
JV –
I had decided on this brand due to so many outstanding reviews along with " writers " for several magazines claiming " top notch ", " outstanding ", " best quality " , etc.. etc… Upon opening the package, it was very clear that the top caps were off centered to the bottom rings.Had them back in the package and shipped within the hour. One can understand quality control issues.This is what happens when one reads to many reviews of a product. Despite the offset, they look really nice!