GG&G 30mm To 1 Inch Scope Ring Reducer let you use the increasingly common and popular 30mm scope rings with any 1″ diameter rifle scope. The GG&G 30mm Scope Ring Adapters are a non-marring, 30mm to 1 inch scope ring insert that fits 5/8 inch wide sniper grade 30mm scope rings, like the ones offered by GG&G Tactical separately or as integral ring bases. GG&G 1 inch Ring Reducers are manufactured from solid Delrin – nothing fancy, just a rugged machined ring insert that not only fits tight to your 1 inch scope, but is priced competitively. The GG&G One Inch Insert has a recoil flange on one side that keeps the reducer in the correct position during installation and recoil. Each GG&G One-Inch Ring Reducer package includes 4 components, enough to fit 2 scope rings. Specifications for GG&G 30mm to 1in Scope Ring Reducer: Manufacturer: GG&G Finish: Matte Tube Diameter: 1 in Ring Quantity: Single Condition: New Color: Black Country of Origin: USA Features: Both halves of each reducer have a recoil flange on one side that keeps the reducer in the correct position during installation and recoil. Each package includes 4 components; enough parts to do two scope rings. These ring reducers are manufactured from non-marring, non-slip Delrin and very easy to install. Lifetime Warranty. Package Contents: GG&G 30mm to 1in Scope Ring Reducer
6 reviews for GG&G 30mm to 1in Scope Ring Reducer
Only logged in customers who have purchased this product may leave a review.
Related products
Legacy Reviewer –
Color even matched my Trijicon rings.Pros: Works as advertized.Cons: None
Legacy Reviewer –
These are a cheap alternative to purchasing new ringsPros: Easy to setupCons: Plastic
Simon –
Spacers seem to hold the scope tightly enough in the rings, however I was disappointed at how narrow they were in the scope rings. They could have been wider to give more holding power between the rings and scope. A.R.M.S. used previously where much better.
Legacy Reviewer –
These are on a 10-40 scope on a a national match armalite m-4 with armalite one piece ring set. They adapt the rings well enough for the armalite to print like a typewriter at 300 yards given the right load. Another set of the right rings would cost $70 or $500 ish for a scope that wasn't as good. if you need it this will do.Pros: Does the jobCons: Getting them situated is a pain
Legacy Reviewer –
I bought these to mount a cheap 1" tube scope I already had. They were bundled with a set of Vortex Precision Matched 30mm scope rings (made by Seekins aparantly) knowing that later down the line I would inevitably purchase a Vortex scope with a 30mm tube to match. These worked as intended, but were not machined perfectly. One half loosely fit around the 1" tube while one half was very snug around the 1" tube. Its a great way to cheaply mount your 1" scopes if you are POSITIVE that you are going to upgrade to the more common 30mm higher end glass tubes down the line. If you plan on sticking with a 1" tube than I would recommend purchasing a dedicated 1" scope ring, as this was just my "bandaid fix" for the time being. Overall, it was just a great low-cost way for me to get by with my scope.Pros: They work as intendedCons: They aren't machined perfectly
Tom –
Simple reducers get the job done. Allowed me to use an older scope with a newer mount. Saved me from purchasing an expensive replacement scope, and allows for upgrade later. Durable precision made, no slippage.